EC153 922-153-000-202/5000 5m Sensor Cable Assembly for Turbine Monitoring Systems

The EC153 922-153-000-202/5000 is a 5 m cable assembly used to connect compatible industrial sensors to their signal conditioning equipment. It is designed for vibration and dynamic pressure measurement systems, including documented gas turbine monitoring applications. The assembly uses a K205A low-noise, two-wire shielded cable with a PTFE outer sheath. One end has a push-pull connector, while the other end is terminated with flying leads for connection to the specified terminals.

The cable forms part of the sensor signal path, so its type and length must match the connected equipment. It is listed in measurement setups using CA901 and CP532 sensors. The correct cable assembly helps maintain the intended connection between the sensor and signal conditioner, which is important when replacing a damaged cable in an existing monitoring system.

• K205A cable construction: Designed for low-noise signal transmission in measurement applications.
• PTFE outer sheath: Provides a protective cable covering for demanding industrial environments.
• Push-pull connector: Allows connection and disconnection without a threaded coupling.
• 5 m cable configuration: Helps match the cable run required by the installed system.

• Verify the full part number to confirm it is the 5 m version.
• Check that push-pull connectors fit smoothly.
• Measure routing length and reserve slack for maintenance.
• Route clear of sharp edges, hot surfaces, and moving parts.
• Wire per wiring diagrams, not just wire colour.

During a scheduled gas turbine maintenance shutdown, a worn sensor cable is replaced with the EC153 922-153-000-202/5000. The maintenance team checks the connector, cable route, and terminal wiring before installation. After reconnection, the signal is checked at the conditioner to confirm stable data transmission before the turbine returns to operation.

• Rotating machinery online protection systems
• Vibration and shaft-position monitoring
• Steam turbine and compressor safety supervision
• Large fan, generator, and high-speed pump condition monitoring
• Oil and gas facilities
• Chemical processing plants
• Power generation facilities
• Metal processing and coal-chemical plants

• Export to 40+ countries
• Complete after-sales service
• Stable supply chain ensuring continuous availability
• COO, COC, and CQ certification support
• Rapid quotation response

• IOCN 200-566-000-112
• IOC4T 200-560-000-113
• IOC4T 200-560-000-111
• RPS6U 200-582-200-013
• CPUM 200-595-045-114
• 3500/32M 149986-02
• IS200ESELH3AAA
• IS200EPCTG1AAA
• IS200EXHSG3AEC
• IS220PSVOH1A

• Professional installation required for optimal performance and safety
• Ensure proper mounting and adequate ventilation
• Comply with all applicable electrical safety standards